Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

Close

ATtiny2313_Module | PCB Design

ATtiny2313_Module
Version 1 - Last update: Oct 3, 2015

Small module based on the ATtiny2313, footprints for the external crystal are available, is not mandatory to use them since the micro-controller already has an internal oscillator that can run up to 8 MHz.

The push button for the Reset was replaced with the resistor R3, that component shouldn't be soldered just make a short circuit between the terminals of the R3 footprints to reset the micro-controller.

It should fit on a breadboard. I haven't had the chance to check the dimensions.

Comments disabled